Article Submitted by Max Dammit

Parts
The wood is 4 mm wood
the white is 1 mm plastic
the brown is 0,5 mm cardboard


Step one


take part 1 and 2 and stick together (both sides)

Step two

take part 1 and 2 and stick on part 3 (both sides)

and this is what you get
Step one


Those are the fins

next the top and the botum

take part 8 and make this shape


Take part 4 and 6 and make this shape


Take part 5 and glue in to this shape
 

Take parts 5 and 7 and put the 7 in part 5 like on the image



Stick part 5 and 6 together


Take part 9 and fold
 

And stick on the fin


And now you need more hands than you have


 

Take part 5/6 and stick on the bottum with the 5 holes to the top


Take parts 11 and stick on the door


Take parts 10 and glue them on the fins, make sure you leave them sticking out the same distance as the thickness of the plastic/board your using.


Cut a strip of plastic/board so it fits between the parts 10 (on the edge of the fin)

Cut out this part out of normal paper (150 gr?)


Stick the strips on


And make half a cilinder of it


Stick them in the lower slots on the pod
 

cut out the rectangle shape out of board/plastick and stick on the botum of the pod


Now for the trusters, You can make a cilinder out of a pice of paper but i use wall plugs


Cut of the end (test the length you want)


and stick in part 10


Take this part and cut


Bend the edges of the rotor
 

Make a cilinder out of the strip


And place the rotor in side (this is fiddly work)


And stick on top of you pod


cut the little square shapes and gleu in the holes on the fins and door

If you'v don it right, this is what you have, just a few more little things to do.
 

Cut out the slim lines and small rectangle shapes on the image and stick on top of the fins to connect parts 3 (top of the fins you see a connection)


Cut these parts


And stick on the botum side of the fins

Than ask around on a board (Thanx Gareth )
and get these or the banners


Stick on the doors and its done